Promotional Item Leak KNX

Leakage Sensor for Water/Pipe Break Detection

The promotion runs until 21.11.2017 in the Elsner Elektronik online shop.
A maximum of 1 promotional item can be ordered per customer.

Promotional item Leakage sensor Leak KNX (70314)

The Leakage sensor Leak KNX includes an evaluation unit and a probe. If there is water between the electrodes of the probe, the evaluation unit produces an acoustic alarm. Additionally, the alarm signal is sent to the KNX bus.

 



  • Detection of water on the probe
  • Acoustic alarm signal by the evaluation unit during a water alarm (sustained
  • beeping tone). Short beeping during the follow-up time (1 minute after the end
  • of the alarm)
  • Alarm signal sent to the KNX bus with a text message
  • 4 AND and 4 OR logic gates with each 4 inputs. Every switching incident as well as 16 logic inputs in the form of communication objects, may be used as inputs for the logic gates. The output of each gate may optionally be configured as 1 bit or 2 x 8 bits
  • Configuration is made using the KNX software ETS 5

Analysis unit:

Casing Plastic
Colour Grey
Installation Surface mounted
Protection category IP 20
Dimensions approx. 105 x 105 x 65 (W × H × D, mm),
Weight approx. 180 g
Ambient temperature Operation -20…+70 °C, storage -55…+90°C.
Ambient humidity max. 95 % RH, avoid condensation
Auxiliary voltage 24 V DC
Power on the bus 10 mA
Data output KNX +/- Bus connector terminal
Communication objects 54
Current Consumption at 24 V DC ±10%
no alarm: max. 15 mA
alarm: max. 30 mA
Probe input 1 x electrode probe, plug-in BNC terminal

Probe:

Casing Polished stainless steel
Installation for placing on the floor
Protection category IP 68
Electrode chemical resistanceWater
Dimensions Diameter: approx. 77 mm
Cable length approx. 140 mm (plus cable grip and plugs)
Weight approx. 200 g
made in germany